Post-impact crater morphology and structure modifications due to sediment loading are analyzed in detail and exemplified in five well-preserved impact craters: Mjølnir, Chesapeake Bay, Chicxulub, Montagnais, and Bosumtwi. The analysis demonstrates that the geometry and the structural and stratigraphic relations of post-impact strata provide information about the amplitude, the spatial distribution, and the mode of post-impact deformation. Reconstruction of the original morphology and structure for the Mjølnir, Chicxulub, and Bosumtwi craters demonstrates the long-term subsidence and differential compaction that takes place between the crater and the outside platform region, and laterally within the crater structure. At Mjølnir, the central high developed as a prominent feature during post-impact burial, the height of the peak ring was enhanced, and the cumulative throw on the rim faults was increased. The original Chicxulub crater exhibited considerably less prominent peakring and inner-ring/crater-rim features than the present crater. The original relief of the peak ring was on the order of 420-570 m (currently 535-575 m); the relief on the inner ring/crater rim was 300 450 m (currently ~700 m). The original Bosumtwi crater exhibited a central uplift/high whose structural relief increased during burial (current height 101-110 m, in contrast to the original height of 85-110 m), whereas the surrounding western part of the annular trough was subdued more that the eastern part, exhibiting original depths of 43-68 m (currently 46 m) and 49-55 m (currently 50 m), respectively. Furthermore, a quantitative model for the porosity change caused by the Chesapeake Bay impact was developed utilizing the modeled density distribution. The model shows that, compared with the surrounding platform, the porosity increased immediately after impact up to 8.5% in the collapsed and brecciated crater center (currently +6% due to post-impact compaction). In contrast, porosity decreased by 2-3% (currently -3 to -4.5% due to post-impact compaction) in the peak-ring region. The lateral variations in porosity at Chesapeake Bay crater are compatible with similar porosity variations at Mjølnir crater, and are considered to be responsible for the moderate Chesapeake Bay gravity signature (annular low of -8 mGal instead of -15 mGal). The analysis shows that the reconstructions and the long-term alterations due to post-impact burial are closely related to the impact-disturbed target-rock volume and a brecciated region of laterally varying thickness and depth varying physical properties. The study further shows that several crater morphological and structural parameters are prone to post-impact burial modification and are either exaggerated or subdued during post-impact burial. Preliminary correction factors are established based on the integrated reconstruction and post-impact deformation analysis. The crater morphological and structural parameters, corrected from post-impact loading and modification effects, can be used to better constrain cratering scaling law estimates and impact-related consequences.

The Ordovician Lockne impact structure is located in central Sweden. The target lithology consisted of limestone and black unconsolidated shale overlaying a Precambrian crystalline basement. The Precambrian basement is uranium-rich, and the black shale is both uranium- and organic-rich. This circumstance makes Lockne a good candidate for testing the occurrence of U-Thrich bitumen nodules in an impact structure setting. U-Th-rich bitumen nodules are formed through irradiation; hence the increase in the complexity of organic matter by a radioactive (uranium- and thorium-rich) mineral phase. U-Th-rich bitumen nodules were detected in crystalline impact breccia and resurge deposits from the impact structure, but samples of non-impact-affected rocks from outside the impact structure do not contain any U-Th-rich bitumen nodules. This implies that in the Lockne impact structure, the nodules are associated with impact-related processes. U-Th-rich bitumen nodules occur throughout the geological record and are not restricted to an impact structure setting, but our studies at Lockne show that this process of irradiation can readily occur in impact structures where fracturing of rocks and a post-impact hydrothermal system enhances fluid circulation. The irradiation of organic matter by radioactive minerals has previously been proposed as a process for concentration of carbon on the early Earth. Impact structures are suggested as sites for prebiotic chemistry and primitive evolution, and irradiation by radioactive minerals could be an important mechanism for carbon concentration at impact sites.

On Earth, oceanic impacts are twice as likely to occur as continental impacts, yet the effect of the oceans has not been previously considered when estimating the terrestrial crater size-frequency distribution. Despite recent progress in understanding the qualitative and quantitative effect of a water layer on the impact process through novel laboratory experiments, detailed numerical modeling, and interpretation of geological and geophysical data, no definitive relationship between impactor properties, water depth, and final crater diameter exists. In this paper, we determine the relationship between final (and transient) crater diameter and the ratio of water depth to impactor diameter using the results of numerical impact models. This relationship applies for normal incidence impacts of stoney asteroids into water-covered, crystalline oceanic crust at a velocity of 15 km s-1. We use these relationships to construct the first estimates of terrestrial crater size-frequency distributions (over the last 100 million years) that take into account the depth-area distribution of oceans on Earth. We find that the oceans reduce the number of craters smaller than 1 km in diameter by about two-thirds, the number of craters ~30 km in diameter by about one-third, and that for craters larger than ~100 km in diameter, the oceans have little effect. Above a diameter of ~12 km, more craters occur on the ocean floor than on land; below this diameter more craters form on land than in the oceans. We also estimate that there have been in the region of 150 impact events in the last 100 million years that formed an impact-related resurge feature, or disturbance on the seafloor, instead of a crater.

Scaling laws describing crater dimensions are defined in terms of projectile velocity and mass, densities of the material involved,strength of the target, and the local gravity. Here, the additional importance of target porosity and saturation, and an overlying water layer, are considered through 15 laboratory impacts of 1 mm diameter stainless steel projectiles at 5 km s^(-1) into a) an initially uncharacterized sandstone (porosity ~17%) and b) Coconino Sandstone (porosity ~23%). The higher-porosity dry sandstone allows a crater to form with a larger diameter but smaller depth than in the lower-porosity dry sandstone. Furthermore, for both porosities, a greater volume of material is excavated from a wet target than a dry target (by 27-30%). Comparison of our results with Pi-scaling (dimensionless ratios of key parameters characterizing cratering data over a range of scales) suggests that porosity is important for scaling laws given that the new data lie significantly beneath the current fit for ice and rock targets on a pi-v versus pi-3 plot (pi-v gives cratering efficiency and pi-3 the influence of target strength). An overlying water layer results in a reduction of crater dimensions, with larger craters produced in the saturated targets compared to unsaturated targets. A water depth of approximately 12 times the projectile diameter is required before craters are no longer observed in the targets. Previous experimental studies have shown that this ratio varies between 10 and 20 (Gault and Sonett 1982). In our experiments ~25% of the original projectile mass survives the impact.

All terrestrial planets, the Moon, and small bodies of the inner solar system are subjected to impacts on their surface. The best witness of these events is the lunar surface, which kept the memory of the impacts that it underwent during the last 3.8 Gyr. In this paper, we review the recent studies at the origin of a reliable model of the impactor population in the inner solar system, namely the near-Earth object (NEO) population. Then we briefly expose the scaling laws used to relate a crater diameter to body size. The model of the NEO population and its impact frequency on terrestrial planets is consistent with the crater distribution on the lunar surface when appropriate scaling laws are used. Concerning the early phases of our solar systems history, a scenario has recently been proposed that explains the origin of the Late Heavy Bombardment (LHB) and some other properties of our solar system. In this scenario, the four giant planets had initially circular orbits, were much closer to each other, and were surrounded by a massive disk of planetesimals. Dynamical interactions with this disk destabilized the planetary system after 500-600 Myr. Consequently, a large portion of the planetesimal disk, as well as 95% of the Main Belt asteroids, were sent into the inner solar system, causing the LHB while the planets reached their current orbits. Our knowledge of solar system evolution has thus improved in the last decade despite our still-poor understanding of the complex cratering process.

Four exposures of Chicxulub impact ejecta along the Mexico-Belize border have been sampled and analyzed for major and trace element abundances. The ejecta deposits consist of a lower spheroid bed, containing clay and dolomite spheroids, and an upper diamictite bed with boulders and clasts of limestone and dolomite. The matrix of both beds is composed of clay and micritic dolomite. The rare earth element (REE) compositions in the matrix of both units show strong similarities in concentrations and pattern. Furthermore, the Zr/TiO2 scatter plot shows a linear correlation indicating one source. These results indicate that the basal spheroid bed has the same source and was generated during the same event as the overlying diamictite bed, which lends support to a single-impact scenario for the Albion Formation ejecta deposits. The elevated concentrations of non-meteoritic elements such as Sb, As, U, and Zn in the matrix of the lower spheroid bed are regarded to have been derived from the sedimentary target rocks at the Chicxulub impact site. The positive Eu and Ce anomalies in clay concretion and in the matrix of the lower part of the spheroid bed in Albion Island quarry is probably related to processes involved in the impact, such as high temperature and oxidizing conditions. Analogous trace element anomalies have been reported from the distal Cretaceous-Paleogene (K/T) boundary clay layer at different sites. Thus, the trace element signals, reported herein, are regarded to support a genetic link between the Chicxulub impact, the ejecta deposits along the Mexico-Belize border, and the global K/T boundary layer.